Problem Solving
PROBLEM | CAUSE | SOLUTION |
|
|
|
There is no steam | Steamer not plugged in | Plug into electrical outlet |
|
|
|
| ON/OFF switch not in | Remove the steam nozzle and hang on door |
| “ON” position | hook. Push the switch to the “ON” position. |
|
| Switch will illuminate. |
|
|
|
| Water tank is low or | Check water tank to be sure it is full. See Filling |
| empty | the Water Tank on page 5. |
|
|
|
| The hose is kinked | Be sure the steam hose is fully extended. |
|
|
|
There is low or | Mineral | Follow the Removing Mineral |
intermittent steam |
| on page 9. |
|
|
|
| Water tank is low | Check water tank to be sure it is full. See Filling |
|
| the Water Tank on page 5. |
|
|
|
Water runs through | Condensation in steam | Hold the hose vertically to allow the water to run |
the steam holes in the | hose | back into the water tank. |
nozzle |
|
|
| The steam hose and | Hold the hose vertically to allow the water to run |
| nozzle are not being | back into the water tank. |
| used in a a vertical |
|
| position |
|
|
|
|
Nozzle gurgles | Condensation in steam | Hold the hose vertically to allow the water to run |
| hose | back into the water tank. |
|
|
|
The steamer takes a | Mineral | Follow the Removing Mineral |
long time to heat |
| on page 9 |
|
|
|
| The water tank is filled | Unplug the steamer, allow it to cool for 30 |
| above the fill line | minutes, remove the steam hose and empty the |
|
| water water tank to the maximum fill line. |
|
|
|
10 | 11 |
