HoMedics SC-650 instruction manual Setting The Zero Point and Balance, Screw

5.Use SCREW DRIVER to hook POTHOOK

into the hole of the LONG ARM CONNECTION PLATE.

Pothook

Long Arm

Connection Plate

6.Use ALLEN KEY to remove pre-set ASS E M B LY SCREW (located on the bottom of the base) to release the LONG ARM CONNECTION PLAT E into place.

Assembly

Screw

7.Use ALLEN KEY to attach POLE to BASE by inserting and turning the 4 SCREWS tightly.

Screws

Setting The Zero Point and Balance

Before using the scale for the first time or when the scale has been moved to another place, you must set the zero point and balance the scale before weighing yourself.

Zero Point

1.With nothing on the PLATFORM, slide the UPPER and LOWER sliding weights to ZERO.

2.To set the POINTER TIP in the middle of the OVAL you must use the ADJUSTING

SCREW.

A. Turn the ADJUSTING SCREW counterclockwise towards “ – “ to raise the POINTER TIP.

B.Turn the ADJUSTING SCREW

clockwise towards “ + “

to lower the POINTER TIP.

Step1

Upper Weight Pointer Tip

Lower Weight

Step2

Adjusting Screw Detail

Adjusting Screw

Side

8.Slide POLE COVER down.

9.Replace PLATFORM by sliding it onto BASE and push down until it snaps into place.

Balance

Place the scale on a flat, firm surface. Turn the 6 LEVELING FEET until the bubble inside

the LEVEL is directly in the middle of the circle. Use LOCKING DIAL to lock LEVELING FEET into place.

Level

Locking

Dial

Platform Top Leveling Feet Leveling Foot

4 5