Assembly and Instructions for Use
1.Unpack the product. Wipe off dust with a damp cloth.
2.Familiarize yourself with the pump. The pump speed is controlled by the switch located at the front of the pump. The speed is indicated by a plus (+) and minus
NOTE: It is recommended the pump be set at its highest speed during assembly and later adjusted to a lower setting if desired. Be sure to unplug the pump before adjusting the speed setting.
6.Attach the adaptor to the power cord. (Fig. 5)
7.Plug the cord into 120V household outlet. The fountain is controlled by a switch located on the power cord. If pump does not operate, rotate
Note: Ensure that the electrical cord loops below the electrical outlet to form a “Drip Loop”. This will prevent water from running down the electrical cord into the electrical outlet. (Fig. 6)
Figure 4
Attention:
In order to get best results, please operate pump completely submerged. Keep the water level above the minimum water level ALL THE TIME.
Figure 1
Minimum Water Level
Flow Control Lever
(+) faster water output
Top | Tube | |
| Slot | |
| Power | |
| Cord | |
Plastic Tube | Cord | |
Slot | ||
| ||
Pump |
| |
| Light |
3.Insert the black connector at the bottom of the plastic tube, attached to the foun- tain top, into the round opening of the pump. (Fig. 2)
4.Fill the base with 24 oz. of clean water. Water level should not rise above support posts. (Fig. 3)
NOTE: We recommend using distilled water to prevent mineral
5.Place fountain top onto base so that it sits flat. Run the plastic tube into the base through the tube slot located at the back of the fountain. Run the power cord and light cords out of the base through the cord slot, also located at the back of the fountain. (Fig 4)
Support Posts | Cords |
| |
| Base |
Figure 2
Top |
|
|
Plastic Tube | Tube |
|
|
| |
| Slot | Cord |
|
| Slot |
Pump |
|
|
|
| Light |
|
| Cords |
Figure 3
Support Posts |
Water |
Base |
Figure 5
Power Cord
Switch Adaptor
4 | 5 |