HoMedics WFL-ISL instruction manual Assembly and Instructions for Use, Minimum Water Level

Assembly and Instructions for Use

1.	Unpack the product. Wipe off dust with a damp cloth.
2.	Familiarize yourself with the pump. The pump speed is controlled by the switch
	located at the front of the pump. The speed is indicated by a plus (+) and minus
	(-) sign. To increase the speed, move the switch slowly to the left in the direction of
	the plus sign. You will hear a click as the switch moves to each speed level. At its
	highest speed level, the switch will cease to move any further. To decrease the pump

9. Attach the Adaptor to the power cord. (Fig. 6)

10.Plug the cord into 120V household outlet. The fountain is controlled by a switch located on the power cord. If pump does not operate, rotate in-line switch once to turn “on” and once to turn “off”.

Note: Ensure that the electrical cord loops below the electrical outlet to form a “Drip Loop”. This will prevent water from running down the electrical cord into the electrical outlet. (Fig. 7)

speed, move the switch to the right toward the minus sign. Similarly, at its lowest

speed, the switch will cease to move any further. (Fig. 1)

NOTE: It is recommended the pump be set at its highest speed during assembly and later adjusted to a lower setting if desired. Be sure to unplug the pump before adjusting the speed setting.

Figure 4

Top

Figure 6

Top

Attention:

In order to get best results, please operate pump completely submerged. Keep the water level above the minimum water level ALL THE TIME.

Figure 1

Minimum Water Level

Flow Control Lever

(+) faster water output

(-) slower water output

Cord Slot

Pump

Water

Support

	Switch
	Adaptor
	Platform
Glass Stones	Base

3.Insert the waterproof light into the light clip located inside the base (Fig. 2) so that lights are facing upwards.

4.Insert the black tube attached to the fountain top into the round opening of the pump. (Fig. 3)

5.Fill the base with 20 oz. of clean water. Water level should not rise above support posts. NOTE: We recommend distilled water to prevent mineral build-up.(Fig.4)

6.Place fountain top onto base so that it sits flat. Run the pump power cord out through the cord slot at the back of the fountain. (Fig. 4)

7.Next attach the four Leaf Cups by inserting the tab, located at the back of each Leaf Cup, into its corresponding notch on the fountain top. Leaf Cups should attach to fountain securely. (Fig. 5)

8.Arrange Glass Stones provided on fountain top platform as desired. (Fig. 6)

Posts

Base

Figure 5

2nd Leaf Notch	Top Leaf Notch
2nd Leaf Cup	Top Leaf Cup
	3rd Leaf Notch
Bottom Leaf	3rd Leaf Cup
Notch
Bottom
Leaf Cup

Figure 2

Base
Light Clip	Waterproof Light

Figure 3

Top	Black
	Tube

Pump

Tab

Base

Leaf Cup

4

5