HoMedics WFL-ISL Maintenance, Troubleshooting, To clean the pump, To keep water clean

Figure 7

Drip Loop

Maintenance

• To clean the pump:

Figure 8

	PVC Tubing
	Inserts Here
	Back Plate
Impeller	Housing
Pump Inlet
Front Plate
	Suction Feet
Flow
Control
Lever

Unplug from electrical outlet. Remove it from the base of the fountain. Use a small brush or stream of water to remove any debris. (Fig 8)

•To keep water clean:

Periodically change water and clean the product according to the water condition. Keeping the water clean prevents the water from becoming sticky and forming micro-organisms. We recommend distilled water to prevent mineral build-up.

•To clean off hard water deposits on the base:

Soak the container in a mixture of vinegar and water to clean and remove any mineral build-up.

•Keeping the water at an optimum level:

Add water periodically to keep water level at an optimum level to avoid shortening the life of the pump.

NOTE: Never let the pump run dry, as this will shorten the life of the pump.

•Fountain Storage

Unplug the fountain from the electrical outlet, empty the water, and store fountain in a dry, cool place.

Caution:

All servicing of this fountain must be performed

by authorized HoMedics service personnel only.

Troubleshooting

•If the pump fails to operate, check the following:

Check the circuit breaker, or try a different outlet to make sure the pump is getting electrical power.

NOTE: Always disconnect from electrical outlet before handling the pump.

• If the pump gurgles, spews, or “burps”:

Check the water level to make sure the pump has enough water to function.

•Obtaining a desired water level:

Check the water level daily the first week to measure the rate of evaporation; refill with water as needed.

•If water is splashing outside the fountain:

Adjust the flow control lever to a lower setting on the pump.

6 7