HoMedics WFL-SLST instruction manual Assembly and Instructions for Use

Assembly and Instructions for Use

1.Unpack the product. Wipe off dust with a damp cloth.

2.Familiarize yourself with the pump. The pump speed is con- trolled by the switch located at the front of the pump. The speed is indicated by a plus (+) and minus (-) sign. To increase the speed, move the switch slowly downward in the direction of the plus sign. You will hear a click as the switch moves to each speed level. At its highest speed level, the switch will cease to move any further. To decrease the pump speed, move the switch upward toward the minus sign. Similarly, at its lowest speed, the switch will cease to move any further (Fig 1). NOTE: It is recommended the pump be set at its highest speed during assembly and later adjusted to a lower setting if desired. Be sure to unplug the pump before adjusting the speed setting.

4.Insert the waterproof light into the light hole located on the underside of the panel. (Fig. 3)

Figure 3

Panel

Waterproof Light

Light Hole

Attention:	Figure 1
In order to get
best results,

Minimum Water Level

5.Join the pump outlet and the connector tube under the panel. (Fig. 4)

please operate

pump completely

submerged.

Keep the water

level above the

minimum water

level ALL THE

TIME.

Flow Control Valve

(+)faster water output

(-) slower water output

Figure 4

Panel

Connector

Tube

Pump

Figure 5

Fountain

Top

Connector Tube

Socket

Panel

3.Place the basin on a flat surface. (Fig. 2) Figure 2

Fountain Top
Stones
	Socket
Panel	Connector Tubes
Light Hole	Waterproof Light
	Switch
Water

Basin

PumpAdaptor

6.Place the panel on top of the basin.

Note: Lead the power cord through the slot located at the top of the basin. This will allow the fountain panel and top to sit evenly on the basin.

7.Insert the top connector into the socket located in the center of the panel. (Fig. 5)

8.Fill the basin with approximately 3 1/2 cups of water. The pump needs to be completely submerged in water in order to work properly.

9.Arrange the rocks on the panel for decoration. Watch for splashing and adjust accordingly.

10.Attach the A/C adaptor jack to the base power cord. (Fig. 2)

11.Plug the cord into 120V household outlet. The fountain is con- trolled by the switch located on the power cord. If pump does not operate, rotate in-line switch once to turn “on” and once to turn “off”.

Note: Ensure that the electrical cord loops below the electri- cal outlet to form a “Drip Loop”. This will prevent water from running down the cord into the electrical outlet (Fig. 7).

4 5