ASSEMBLY
INSTALLING THE HANDLES
See Figure 5.
Locate the following items:
2 handles | 2 clevis pins |
2 small cotter pins |
|
With the generator in normal operating position, find the holes on the frame above the recoil starter.
Align the holes in one of the handle brackets with the holes in one side of the generator frame.
Insert a clevis pin through the handle bracket and frame. The head of the pin should be on the outside of the frame.
Insert the small cotter pin through the hole in the clevis pin. Bend the ends of the pin to secure.
Repeat the above steps to install the second handle.
CAUTION
Do not attempt to lift the unit by the handle assembly. If it is necessary to lift the generator, always grasp by the frame. Use proper lifting techniques to avoid back injury.
COTTER PIN
CLEVIS PIN
GENERATOR
FRAME
HANDLE
Fig. 5
OPERATION
DANGER:
Failure to properly ground generator can result in elec- trocution, especially if the generator is equipped with a wheel kit. National Electric Code requires generator to be properly grounded to an approved earth ground. Call an electrician for local grounding requirements.
WARNING:
Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is suf- ficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury.
APPLICATIONS
This generator is designed to supply electrical power for operating compatible electrical lighting, appliances, tools, and motor loads.
Page 14