ASSEMBLY
UNPACKING
This product requires assembly.
Remove one end of the box and carefully slide out the generator and any accessories.
NOTE: The generator is heavy. If you must lift the unit out of the box, get another person to help you and lift with your legs, not your back.
Inspect the unit carefully to make sure no damage oc- curred during shipping.
Do not discard the packing material until you have carefully inspected and satisfactorily operated the product.
If any parts are damaged or missing, please call
WARNING:
If any parts are damaged or missing do not operate this product until the parts are replaced. Failure to heed this warning could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
SMALL
COTTERWHEEL
PIN
LARGE
COTTER
PIN
| |
AXLE | Fig. 3 |
|
BOLT
HOLE
FRAME SUPPORT
WITH FOOT
WARNING:
Do not attempt to operate the generator until assembly is complete. Failure to comply could result in possible serious personal injury.
INSTALLING THE WHEELS
See Figure 3.
Wheels are provided to assist in moving the generator to the desired location and should be installed on the side opposite the recoil starter.
NOTE: Install the wheels before installing the handle. Do not put fuel or oil in the generator before installing the wheels.
Locate the following items:
2 wheel axles | 2 wheels |
2 small cotter pins | 2 large cotter pins |
Raise the end of the generator opposite the recoil starter high enough to gain access to the frame bottom; securely position props underneath to support.
Locate the
On the end that extends inside the generator frame, insert a small cotter pin through the hole in the axle to secure. Bend the ends of the cotter pin to prevent the pin from slipping out.
Fig. 4
Place a wheel over the other end of the axle.
Insert a large cotter pin through the hole in the axle. Bend the ends of the pin to secure.
Repeat the process on the other side.
INSTALLING THE FRAME SUPPORTS
See Figure 4.
Install the two frame supports provided on the bottom side of the generator frame opposite the wheels.
Locate the following items:
2 frame supports | 6 bolts |
Raise the end of the generator where the recoil starter is located high enough to gain access to the frame bottom; securely position props underneath to support.
Align the holes on the frame support with the holes on the generator frame.
Insert a bolt through the hole in the generator frame so it extends down through the frame support.
Tighten bolt to secure.
Repeat with the two remaining screws.
Repeat on other side to install second frame support.
Page 13