CU50
Service Manual
Harvest Time Adjustment
The harvest time can be adjusted so that all the ice harvests during the cycle, plus a few seconds extra. This is done by a button press sequence.
Note: Do not set harvest time shorter than the actual time it takes to release all the cubes.
To adjust Harvest Time:
1.Shut the machine off by holding the On/Off button in until it shuts off (Ice Making light off).
2.Press and hold the On button again for 5 seconds, then release (Ice Making light will switch off).
3.View the lights. Compare to the table below.
Harvest Time Table
| On/Off | Water | Clean |
Default | off | off | off |
Add 10 seconds | on | off | off |
Add 20 seconds | off | on | off |
Add 30 seconds | off | off | on |
Add 40 seconds | on | on | on |
- 10 seconds | flash | off | off |
- 20 seconds | off | flash | off |
- 30 seconds | off | off | flash |
- 40 seconds | flash | flash | flash |
4.Select the amount of change.
5.Push and release the Clean button until the correct light pattern is displayed.
6.Push and release the On button to select that setting.
7. Push and release On/Off to return to ice making.
Ice Making | Check Water |
Indicator Light | Indicator Light |
On - Off | Time To | Clean - Reset | |
Button | |||
Button | Clean Unit | ||
| |||
| Indicator Light |
| |
|
|
| |
| Control Panel |
|
March 2010
Page 12
