Function Mode and Adjustment
6
6.7.3 o3: P-P Auto Exposure Coarse Adjustment
This adjustment is made when the image density on the print (scan) output in the Auto Exposure mode is not satisfactory.
This adjustment is necessary after the replacement of
Be sure to adjust the Projection Lamp Voltage (F7) and Shading Correction (b6) before this Adjustment.
1.Turn the Power Switch, set the Auto Exposure Mode into Auto and select the center position of exposure level.
2.Make a print (scan) and check the image density.
<Conditions of printing/scanning>
Print Mode | Text |
Film Type | Posi |
3.Refer to the charts given below.
Then, adjust to desired image density by Function Mode o3.
o3
Setting | Function | Image density | |
|
|
|
|
d4 | 4 step lighter | Lighter | |
|
|
|
|
d5 | 3 step lighter |
|
|
d6 | 2 step lighter |
|
|
|
|
|
|
d7 | 1 step lighter |
|
|
|
|
|
|
d8 | Standard |
|
|
|
|
|
|
d9 | 1 step darker |
|
|
|
|
|
|
dA | 2 step darker |
|
|
|
|
|
|
db | 3 step darker |
|
|
|
|
|
|
dC | 4 step darker | Darker | |
|
|
|
|
93
