ASSEMBLY
WARNING:
Stop the engine and disconnect the spark plug wire before installing parts, making adjustments, cleaning, or when not in use. Failure to do so could result in possible serious personal injury.
ASSEMBLING THE BLOWER TUBES
See Figure 2.
1.Screw the nozzle onto the upper blower tube and tighten securely. Check tightness after initial run and retighten if needed.
2.Place clamp around the neck of the blower housing outlet. Do not tighten the wing nut yet.
3.Align the locking tab on upper blower tube with the slot in the blower housing outlet; push the tube into the housing. Twist to lock into place.
4.Rotate the tube so the nozzle is pointing upward as shown. Tighten the wing nut securely.
5.To remove the tubes, loosen the wing nut on the clamp. Rotate the tubes to unlock them remove from the blower housing outlet.
INSTALLING THE VACUUM BAG
See Figures 3 and 4.
1.Remove the nozzle and upper blower tube from the blower.
2.Unzip the vacuum bag and place the adaptor inside as shown.
3.Align the locking tab on the bag adapter with the slot in the blower housing outlet; push the bag adaptor into the housing. Twist to lock into place.
4.Tighten the wing nut securely.
5.Rotate the vacuum bag until the shoulder strap is upright.
6.Make sure the vacuum bag is zipped and closed before starting the unit.
NOZZLE | UPPER TUBE |
Fig. 2
ADAPTOR
VACUUM BAG
Fig. 3
Fig. 4
Page 9
