TROUBLESHOOTING
Problem | Possible Cause | Solution |
Handle not in position. | Carriage bolts not seated properly. | Adjust the height of the handle and |
|
| make sure the carriage bolts are |
|
| seated properly. |
| Handle knobs not tightened. | Tighten handle knobs. |
|
|
|
Mower not starting. | Extension cord not connected to the | Reconnect the cord and use the cord |
| mower plug. | retainer to keep the cord close to the |
|
| motor/blade control. |
| Extension cord not connected to | Connect the extension cord to a live |
| power source. | 120V AC, 60 HZ AC receptacle. |
| Tripped circuit breaker in the house. | Reset house circuit breaker. If it trips |
|
| again, call a qualified electrician. |
| Motor control switch defective. | Have motor control switch replaced |
|
| by an authorized service center. |
|
|
|
Mower cutting grass unevenly. | Lawn is rough or uneven or cutting | Move the wheels to a higher posi- |
| height not set properly. | tion. All wheels must be placed in the |
|
| same cutting height for the mower |
|
| to cut evenly. |
|
|
|
Mower not mulching properly. | Wet grass clippings sticking to the | Wait until the grass dries before |
| underside of the deck. | mowing. |
|
|
|
Mower hard to push. | High grass, rear of mower housing | Raise cutting height. |
| and blade dragging in heavy grass, or |
|
| cutting height too low. |
|
|
|
|
Mower vibrating at higher speed. | Blade is unbalanced. | Balance the blade by grinding each |
|
| cutting edge equally. |
| Bent motor shaft. | Stop the motor, disconnect the |
|
| power source, and inspect for dam- |
|
| age. Have repaired by an authorized |
|
| service center before restarting. |
|
|
|
CALL US FIRST
For any questions about operating or maintaining your product,
call the Homelite® Help Line!
Your product has been fully tested prior to shipment to ensure
your complete satisfaction.
Page 17
