ASSEMBLY
UNPACKING
This product has been shipped completely assembled.
Carefully remove the items from the box. Make sure that |
all items listed in the packing list are included. |
GUIDE
POWER HEAD
SHAFT
COUPLER
Inspect the product carefully to make sure no breakage |
or damage occurred during shipping. |
Do not discard the packing material until you have care- |
fully inspected and satisfactorily operated the tool. |
If any parts are damaged or missing, please call |
PACKING LIST
Hanger Cap
Operator’s Manual
WARNING:
If any parts are damaged or missing, do not operate this tool until the parts are replaced. Failure to heed this warning could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso- ries not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
CONNECTING POWER HEAD TO EXTENSION SHAFT AND TILLER ATTACHMENT
See Figure 2.
The tiller attachment connects to the power head or, for extra reach, to an extension shaft by means of a coupler device.
WARNING:
Never attach or adjust any attachment while power head is running. Failure to stop the engine and disconnect the spark plug wire or disconnect from power supply may cause serious personal injury.
RECESS
BUTTON
POSITIONING
HOLEKNOB
TILLER SHAFT
Fig. 2
To install the attachment:
Loosen the knob on the coupler of the power head shaft and remove the end cap from the attachment.
� Push in the button located on the shaft of the tiller attach- ment.
� Align the button with the guide recess on the power head coupler and slide the two shafts together. Rotate attach- ment shaft until button locks into the positioning hole.
NOTE: If the button does not release completely in the positioning hole, the shaft is not locked into place. Slightly rotate from side to side until the button is locked into place.
� Tighten the knob securely.
WARNING:
Be certain the knob is fully tightened before operating equipment; check it periodically for tightness during use to avoid serious injury.
To remove:
� Loosen the knob.
� Push in the button and twist the shafts to remove and separate ends.
7
