MAINTENANCE
WARNING:
When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause product damage.
WARNING:
Always wear safety goggles or safety glasses with side | HOLE |
shields during tool operation. If operation is dusty, also |
|
wear a dust mask. |
|
HANGER |
CAP |
WARNING:
Before inspecting, cleaning, or servicing the machine, shut off engine, wait for all moving parts to stop, and disconnect spark plug wire and move it away from spark plug or disconnect from power supply. Failure to follow these instructions can result in serious personal injury or property damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum- based products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or de- stroy plastic which may result in serious personal injury.
You can often make adjustments and repairs described here. For other repairs, have the tool serviced by an authorized service dealer.
TINE MAINTENANCE
Occasionally apply a few drops of oil to the shaft to keep the tines free on the shaft.
If tines are being replaced due to wear, all four tines should be replaced as a set.
SECONDARY
HOLE
BUTTON
Fig. 9
ATTACHING THE STORAGE HANGER
See Figure 9.
There are two ways to hang the attachment for storage.
To use the hanger cap, push in the button and place the hanger cap over end of the lower end attachment shaft. Slightly rotate the cap from side to side until the button locks into place.
The secondary hole in the attachment shaft can be used for hanging purposes as well.
STORING THE TILLER ATTACHMENT
Store the tiller attachment in a
11
