OPERATION
STARTING AND STOPPING
See Figure 8 and 9.
TO START A COLD ENGINE:
1.Lay the trimmer on a flat, bare surface.
2.Make sure the switch is in the run “I” position.
2.Push the primer bulb 8 to 10 times.
3.Set the choke lever to the choke position 
.
4.Squeeze the throttle trigger to the full throttle position.
5.Pull the starter until the engine tries to run. No more than 6 pulls.
6.Set the choke lever to the half choke position 
.
7.Hold the trigger and the pull starter rope until the engine runs.
8.Run the engine 30 to 45 seconds at full throttle (with the
trigger depressed fully) on half choke position 
to warm up the engine. Move the choke lever to the run position 
.
TO START A WARM ENGINE:
1.Move the choke lever to the run position 
.
2.Hold the trigger and pull the starter rope until the engine runs.
TO STOP THE ENGINE:
To stop the engine, press and hold the switch in the STOP position “O”.
IGNITION SWITCH
I= ON TO RUN O = OFF TO STOP
THROTTLE INTERLOCK
THROTTLE
TRIGGER
Fig. 8
PRIMER BULB
CHOKE LEVER
RUN POSITION
3 |
|
2 |
|
1 | HALF |
| |
| CHOKE |
| POSITION |
| CHOKE |
| POSITION |
| Fig. 9 |
Page 10
