ASSEMBLY
If your unit has been preassembled, check each step to make sure the unit has been properly assembled.
HANDLE
See Figure 4.
1.Remove the front handle, bolt, and wing nut from the Owner’s Kit.
2.Install the front handle onto the top side of the drive shaft housing and move it to a comfortable position.
3.Place the bolt through the front handle as shown, then install the wing nut.
4.Tighten wing nut securely.
GRASS DEFLECTOR
See Figure 5.
1.Remove wing nut, flat washer, lock washer, and bolt from the Owner’s Kit.
2.Place grass deflector over shaft and bracket.
3.Install bolt through the slots in the tabs on grass deflec- tor and bracket on driveshaft housing.
4.Install flat washer, lock washer and wing nut.
5.Tighten Securely.
Page
FRONT HANDLE
WING
NUT
BOLT
Fig. 4
BOLT | GRASS |
| DEFLECTOR |
BRACKET
LOCK WASHER
FLAT |
|
|
WASHER | WING NUT | Fig. 5 |
| ||
|
|
