OPERATION
ADJUSTING DEPTH OF CUT
See Figures 7 - 8.
The depth of cut is determined by the distance from the bottom of the wheel to the tip of blade.
To adjust the blade depth:
Stop the engine. Disconnect the spark plug wire and move it away from spark plug.
Loosen the adjusting knob and move the wheel arm up to increase the depth or down to decrease the depth.
After adjustment is complete, tighten the adjusting knob securely.
Reconnect the spark plug wire and start the unit.
NOTE: Adjust the blade depth from 1/2 in. to 1 in. deep initially. Make a shallow cut to test the cutting depth. If the cutting depth needs adjusting, this should be done progres- sively until the desired depth is reached.
adjusting
knobto increase depth
wheel arm
to decrease |
|
depth | Fig. 7 |
BLADE
DEPTH
Curb Guide | Blade |
Fig. 8 |
Page 12
