HomeTech SAM-V8M manual Terminate Premise Wiring, Alarm Interface Connection, Direct Distribution

Terminate Premise Wiring:

Direct Distribution

Run twisted pair cable from the telephone jacks throughout the premise to the numbered distribution jacks. Terminate modular 8 position plugs to the horizontal cables using the 568A wire standard.

Patch Panel Distribution

Run twisted pair cable from the telephone jacks throughout the premise to the 110 IDCs of a SAM-D8patch panel using the termination procedure above. Connect the numbered distribution ports of the SAM-V8Mto the desired ports of the SAM-D8patch panel with 8 conductor patch cords.

Note: The 3” jumper cord must be plugged into the “OUT” & “TEST” ports to provide service to premise wiring.

Alarm Interface Connection:

The SAM-V8Mfeatures a security interface port which may be connected to a security system; in an emergency situation, the security system can seize telephone service on LINE 1 when the alarm is activated. Connect 8 conductor cord from alarm dialer to the “Security RJ31” port on the SAM-V8M.