OPERATION
CONNECTING THE BAGGER CART
Park the tractor on a flat, level surface. Set the parking
brake and remove the ignition key to prevent accidental CLEVIS PI starting. The following instructions are for the HA411 8
and HA4120 tractors only. Refer to the hitch kit installation instructions for other tractor models.
1, Lift the bagger cart frame towards therear hitch. Install the two clevis pins and spring clips as shown.
SPRING CLIP (2) ’ | \ |
2.HA4120 with the 48” Deck: Lift the middle chute and install it on the lower chute on the side blower. Connect the rubber strap to the tension release lever.
3.HA4118 with the 38” Deck: Lift the discharge guard, and install the lower chute onto the rear edge of the mower deck first, then turn the chute toward the front. Install the connector bracket and clip onto the mower deck. Slide the middle chute onto the lower chute, then connect the
CONNECTOR BRACKETCLIP
INSERT BACK EDGE OF CHUTE FIRST
LOWER CHUTE | \ | ./ |
|
|
TURN TO FRONT
EYEiET
6 | BClOOO BAGGER CART |
