5
GET THE MOWER READYMulching Plug
(HRR)
The mulching plug helps to
curve the inside of the
mower deck for more
efficient mulching.
Install and remove the
mulching plug by raising
the rear discharge guard
as shown. The mulching
plug only fits one way.
Remove the mulching plug
when using a grass bag.
Side Discharge Chute
(HRS)
To discharge clippings to
the side, install the side
discharge chute as shown.
Remove the side discharge
chute when mulching.
Grass Bag
(HRR)
A lawn mower works like a vacuum cleaner; it blows air through the
bag, which traps the grass clippings. Always empty the grass bag
before it becomes filled to the limit of its capacity. Bagging
performance will diminish after the bag becomes about 90% filled.
Also, the bag is easier to empty when it is not packed full.
Inspection
During normal use, the grass bag material is subject to deterioration
and wear.
NOTICE
Frequently inspect the grass bag for tears, holes, and excessive wear.
Check for necessary replacement. Make sure the new bag meets the
original specifications.
Grass bag replacement is explained on page 3.
Installation
1. Raise the discharge guard and hook the grass bag onto the mower
deck as shown.
2. Release the discharge guard to secure the grass bag.
Removal
1. Raise the rear
discharge guard,
grasp the grass bag
handle and remove
the grass bag.
2. Release the rear
discharge guard.
3. When the grass bag
is clear of the rear
discharge guard, you
can lift it through the
handlebar opening,
or you can remove it
to the rear of the
mower below the
handlebar.
Cutting Height Adjustment
The cutting height figures are approximate. The actual height of cut
grass will vary with lawn and soil conditions.
To adjust the cutting height, pull each adjustment lever toward the
wheel, and move it into another notch.
If you are not sure what cutting height to select, start with a high
setting and check the appearance of the lawn after mowing a small
area. Then readjust cutting height if necessary.
The mower deck can be set to any of the six approximate settings.
Each wheel should be adjusted to the same position.
REAR
DISCHARGE
GUARD
MULCHING
PLUG
SIDE
DISCHARGE
GUARD
SIDE DISCHARGE CHUTE
Lower deck Move both the front and rear adjusters backward.
Raise deck Move both the front and rear adjusters forward.
GRASS BAG
HANDLE
BAG
REAR DISCHARGE GUARD
HRS
1" (25 mm)
1-1/2 " (37 mm)
2" (50 mm)
2-1/2" (66 mm)
3" (75 mm)
3-1/2" (87 mm)
HRR
3/4" (19 mm)
1-1/4 " (29 mm)
1-3/4" (41.5 mm)
2-1/4" (54 mm)
2-3/4" (67 mm)
3-1/4" (79 mm)
FRONT
ADJUSTMENT
LEVER
REAR
ADJUSTMENT
LEVER
RIGHT SIDE SHOWN
FORWARD