DEALER ASSEMBLY

INSTRUCTIONS

1Install female end of driveline onto Tiller gearbox input shaft and secure with proper quick locking device Fig. 3.

2Attach three point hitch mast struts and

driveline shield to tiller frame using M12x30 mm. bolts, lock washers and nuts Fig.2.

3Attach mast braces to mast struts using a M12x90mm bolt, spacer, nut and jam nut Fig. 4.

4Secure mast brackets onto clamps on gearbox housing using a M12x80mm spacer, nut and jam nut.

5Install hitch.pin brackets onto frame using two M12x9Omm bolts, with lock washers. Fig. 5

Brackets must be installed with the weld nut

I

on top side maintaining a distance of 19-3/4”(501 mm) centered between brackets. Fig. 6.

6Check gearbox oil level per instructions in LUBRICATION section.

7Make certain all safety shields and safety labels are in place and in good condition.

8Check the tiller tine bolts to ensure they are tight.

Torque to 73 ft. lbs. (10.1 Km) Fig. 7.

9Apply a coating of grease to the telescoping parts of the driveline Fig. 8.

10 Using a grease gun and a multi-purpose grease, ensure the tiller tine shaft and the driveline are lubricated Fig. 9

n Fig. 3

I-=-”””

(501 mm)

hltchplnbracket

Fig. 6

6

Page 10
Image 10
Honda Power Equipment TL5040 manual Dealer Assembly Instructions