Fig. 11
,
Fig.
13
Fig.
12
TILLER ADJUSTMENTS
DEPTH ADJUSTMENT
Position the tiller skids (one on each side) to the
desired tilling depth. To adjust, raise the tiller off
the ground and block it securely in position.
Loosen the skid pivot bolt. Remove the adjusting
bolt. Pivot the skid to the desired depth position
hole, reinstall the adjusting bolt and tighten se-
curely. Retighten the pivot bolt. Repeat this proce-
dure for the opposite side.
Operation without the skids installed can
damage the tiller.
Approximate tilling depth (Fig. 16)
Hole position 4 5.00 inches (127mm)
3 2.50 inches (64mm)
2 1.25 inches (32mm)
1 0.25 inches (6mm)
Note: To achieve the desired tilling depth, it is
common to require several passes with the tiller,
depending on soil condition.
Pivot
Bolt
-
9