Honeywell 17005 owner manual ProgrammableControlFeatures, Set-Up, ManualOperation

Fig. 2

ProgrammableControlFeatures

Fig. 1	Your programmable control features include (Fig. 1):
	•	Manual control or automatic programmed operation
	•	3 Speed settings
	•	Customize set program times
	•	Clock
	• Intelli-CheckTMPre-filter life monitor bar
	• Intelli-CheckTMHEPA filter life monitor bar
	•	Filter reset function
	•	Low battery indicator

Set-Up

•CONNECT THE BATTERY. The programmable controls and real time clock are battery backed. Upon initial set-up, pull the protective film from the battery door so the battery will make contact and function (Fig. 2). This

battery allows you to temporarily unplug your air cleaner without losing program settings.

speed filter

•INSTALL PRE-FILTER BEFORE USE. Locate the initial pre-filter in the packaging. Refer to the "How to Install and

Replace the Filters" section for proper installation.

•SET CURRENT TIME. Plug unit in outlet.

minutes

NOTE: The air cleaner cannot be programmed unless it is plugged into the outlet. Hold SET button down for

approximately 3 seconds. The clock icon and word TIME will appear. You may adjust the hours using the up button and adjust the minutes using the down button. After the current time is set, repeatedly press SET button until ( ) disappears.

ManualOperation

The default program setting upon initial start-up is Manual Operation.

•To go from Automatic Operation to Manual Operation press the PROGRAM button until both PG1 and PG2 disappear.

•To change the speeds in Manual Operation mode press the SPEED button to select the desired setting.

•The SPEED button will move through HIGH, MED, LOW, and OFF as noted on the display, and will function independent of programmed settings.