Removing/Changing the Filters
INSTALL
The initial
•DISCONNECT from power supply before servicing.
•Replace filter(s) and
•Plug in and RESET appropriate filter monitor(s).
To Remove HEPA Filter for Cleaning:
•Unscrew handle
•Remove top cover.
•Remove the filter assembly (consisting of the HEPA filter and
Fig. 2 Open Close
Handle Handle
HEPA
Filter
• Locate the seam of the | Fig. 3 | Groove | |
| the fastener to remove the | ||
|
|
| |
• | Discard used |
|
|
| if necessary. |
|
|
• | Replace HEPA Filter (there is no top or bottom to filter). |
|
|
• Replace top cover. | Push |
| |
• Insert and tighten handle clockwise. | in on |
| |
both tabs |
| ||
To Replace | to release |
| |
Base Ring |
|
•Place unit on its side.
•Push in on both tabs on base ring to release base (Fig. 3).
•Gently remove base from motor assembly.
•Install initial
•Align base into grooves and gently snap back into place.
5