GENERAL OPERATION
WARNING
Water heaters are heat producing appliances. To avoid damage or injury, do not store materials against the water heater or
CIRCUMSTANCES MUST FLAMMABLE MATERIALS, SUCH AS GASOLINE OR PAINT THINNER BE USED OR STORED IN THE VICINITY OF THIS WATER HEATER,
TO FILL THE WATER HEATER
1.Close the water heater drain valve by turning the knob clockwise .
2.Open the cold water supply
3.Open several hot water faucets to allow air to escape from the system.
4.When a steady stream of water flows from the faucets, the water heater is filled. Close the faucets and check for water leaks at the water heater drain valve, combination temperature and pressure relief valve and the hot and cold water connections.
TO DRAIN THE WATER HEATER
Should it become necessary to completely drain the water heater, make sure you follow the steps below:
1.Set the thermostat dial to the lowest possible position.
2.Rotate and if applicable partially depress gas control knob clockwise
to the “OFF” position.
3.Shut off the gas supply to the water heater.
4.Close the cold water supply
5.Open the drain valve on the water heater by turning the knob counter-
clockwise . The drain valve has threads on the end that will allow the connection of a standard hose coupling.
6.Open a hot water faucet to allow air to enter the system. To refill the water heater, refer to “To Fill the Water Heater.”
18