5800ZBRIDGE
Z-Bridge Module
INSTALLATION AND SETUP GUIDE
GENERAL INFORMATION
5800ZBRIDGE is a wireless, intelligent energy management device that provides an interface between
Note: The 5800ZBridge is not compatible with the 5800TM or 5883H modules.
Features
•Automatically set back
•Automatically turns lights off when security system is Armed AWAY.
•Sends run command to
•Automatically turns lights on when security system is Disarmed.
•Alarm Status light: Ready, Armed Away and Stay.
•Will function with any
MOUNTING
1.Determine the optimum mounting location taking care to avoid damp locations. To maximize the transmitter’s range, avoid mounting the device to metal objects, if possible. The module should be located a maximum of 6 feet from an unswitched 120VAC outlet.
2.Open the 5800ZBRIDGE case as shown in Figure 1.
3.Mount the 5800ZBRIDGE using the provided screws. (Refer to Figure 2)
Figure 1. Opening the 5800ZBRIDGE
POWER UP MODULE
1.Plug in 12VDC power supply, LED flashes ORANGE 3 times and then goes out. (Refer to Figure 2)
PROGRAMMING
Enroll 5800TM Code into Module
1.Press SW5 LEARN switch for 1 second and release. LED will begin flashing ORANGE.
2.Disarm or Arm the control panel (with 5800TM code turned on). The LED will stop flashing ORANGE and the color will follow status of the control panel.
Note: The module will time out of program mode after 3 minutes if no TM code is enrolled.
Table 1 - 5800ZBRIDGE LED Indications
Indication | Meaning |
Flashing Red | Armed AWAY |
Steady Red | Armed STAY |
Solid Green | Ready |
Flashing Orange | ALARM/Panic |
Note: Following an alarm, the User Code must be entered twice and the keypad must go to ready in order for the
Enroll (include) Devices in
1.Press the corresponding switch (SW1 through 4) for 1 second and release for any combination of four Thermostats or Lights. (Refer to Figure 2)
2.The 5800ZBRIDGE LED will begin flashing Green.
3.Press button on the respective
4.Repeat for each
Note: The module will time out of program mode after 2 minutes if no
Reset 5800ZBRIDGE Module
1.Disconnect the 12VDC power supply.
2.Press and hold SW5 LEARN switch and then plug in 12VDC power supply. LED flashes Orange 5 times and then goes out.
3.Release switch SW5. TM code has been deleted and 5800ZBRIDGE has been deleted (excluded) from the
- 1 -