K0667 12/01 Rev. B
$'(0&2
:LUHOHVV%LGLUHFWLRQDO$OSKD.H\SDG
USER GUIDE
KEYPAD FEATURESDISPLAY
The 5839 is a wireless keypad that allows you to perform the same functions as you can from a wired keypad, as well as to display the status of your security system. The 5839 should be used as an auxiliary keypad in addition to one or more wired keypads. It should not be used as the only or primary keypad.
KEYPAD KEYS
To access the keypad keys, simply open the
The function keys include keys for panic alarm activation. The panic alarms are activated by pressing key pairs
[1]& [✱], [3] & [#], or [✱] & [#], or a Special Function Key (see below). Whether these panic keys are functional and the type of panic alarms they produce, is determined by the control panel’s capability and programming. (Check with your installer for the availability and assignment of these panic keys.)
SOUNDER
The keypad’s
SPECIAL FUNCTION KEYS
These are four larger keys located to the left of the numeric keys (see Figure 2). The keys may be programmed by your installer for panic alarms or other special functions such as
Special Function keys must be held down for at least 2 seconds to activate an alarm. (Check with your
installer for the programmed function of these keys.)DOOR RELEASE SLOT
5839_kypd
DISARMED
READY TO ARM
1 2 3
OFF AWAY STAY
4 5 6
MAX TEST BYPASS
7 8 9
INSTANT CODE CHIME
* 0 #
READY
PANIC
SPECIAL
FUNCTION KEYS
FIRST PRESS ANY KEY TO PLACE KEYPAD INTO ACTIVE STATE.
THEN PRESS * KEY
TO OBTAIN STATUS.
Figure 1: 5839 Keypad w/ Protective Door Closed | Figure 2: 5839 Keypad w/ Protective Door Removed |
To make sure the latest system status is displayed, press the [✱] key before and after entering each command.
HOW TO GET SYSTEM STATUS
Inactive Mode:
If the 5839 keypad is inactive (with a blank display), press any key (to activate), then press the [✱] key to display present system status.
Active Mode:
In the active mode (connected to a hardwired 9V power pack), the display continuously displays the present security system status. When the keypad is active and there is a change in system status (such as going from an ARMED STAY to DISARMED), it may take up to 20 seconds for the display to automatically update the status to show the status change. However, you can press the [✱] key to update the display immediately.