INSTALLATION

CABLE INSTALLATION (INTERFACE SPECIFIC)

Keyboard Wedge

1.Turn off the host system.

2.Disconnect the keyboard from the host.

3.Connect the keyed VLink cable to the

10-pin Multi-Interface jack. It is the only circular keyed jack located on the bottom of the 7820 (see figure 6).

4.Connect the “Y” end of the VLink cable to the keyboard

and the keyboard port on the host. If necessary, use the male/female adapter cable supplied with the scanner for proper connections.

Before continuing, verify the VLink cable is connected to the appropriate interface jack on the scanner. An incorrect cable connection can cause communication problems or potential damage to the scanner.

5.Connect the external power supply to the power jack on the scanner.

6.Check the AC input requirements of the power supply to make sure the voltage matches the AC outlet.

7.Connect AC power to the transformer. The outlet should be near the equipment and easily accessible.

Figure 6.

Keyboard Wedge Interfaces

8.

Scan the Recall Defaults bar code

Recall Defaults

 

 

to configure the 7820 for

 

 

 

 

 

 

 

Keyboard Wedge communication.

 

 

 

 

 

 

9.

Turn on the host system.

 

 

 

 

 

 

 

³

9

9

9

9

9

8

10. Snap on the cable cover.

See SELV Power caution statement located on page 11 of this manual.

13