Honeywell manual n Description, o Installation, Supplied Parts, 08160 TH106 TL6160

08160

TH106

TL6160

Time and day

Set the day

Set the time

Program the schedule

Skip a period

Select the mode of operation

Indicates the heating power

Temperature preset buttons

Indicates that the temperature setpoint

is displayed

Indicates that the settings are locked

Temperature

Indicates the current mode of operation

Temperature preset icon

	Indicates that the
	thermostat is configured
	for a fan-forced heater
	Indicates the current
	period (appears in
Temperature	automatic mode only)
	Indicates that the ther-
adjustment
buttons	mostat is without power *

NOTE: Always keep the thermostat's vents clean and unobstructed.

n

oConnect the thermostat wires to the line wires and to the load wires using solderless connectors for copper wires.

*LP appears only for the first two minutes when the thermostat is without power. This can occur during a power outage or when the thermal protection device inside the base- board heater is opened.

nDescription

This programmable thermostat can be used to control an electric heating system such as an electric baseboard heater, a radiant ceil- ing, a radiant floor, a convector or a fan-forced heater.

The thermostat cannot be used with:

•a resistive load over 16.7 A

•a resistive load under 2 A

•a system driven by a contactor or relay (inductive load)

•a central heating system

SUPPLIED PARTS:

•One (1) thermostat

•Two (2) 6-32 screws

•Two (2) solderless connectors

oInstallation

TURN OFF POWER TO THE HEATING SYSTEM AT THE MAIN POWER PANEL TO AVOID ELECTRICAL SHOCK. THE INSTAL- LATION MUST BE PERFORMED BY AN ELECTRICIAN.

All cables and connections must conform to the local electrical code.

Special CO/ALR solderless connectors must be used when con- necting with aluminum conductors.

Install the thermostat onto an electrical box.

Install the thermostat about 5 feet high, on an inside wall facing the heater.

Avoid locations where there are air drafts (such as the top of a staircase or an air outlet), dead air spots (such as behind a door), or direct sunlight.

Do not install the thermostat on a wall that conceals chimney or stove pipes.

The thermostat wires are not polarized; either wire can be con- nected to the load or to the power supply.

2-wire installation

4-wire installation

pPush any excess wire back into the electrical box.

NOTE: If necessary, before re-installing the front component, config- ure the thermostat (see section 3).

qReturn power to heating system.

08060 / TH106 / TL6061	69-2202-04	2010-04-06	1/4
Programmable Thermostat - Installation and User Guide