SETTING UP THE COMPACT REFRIGERATOR
UNPACKING
Remove all packing materials and accessories. Examine the compact refrigerator for any damage such as dents or broken door. Do not install if the refrigerator is damaged.
Do not tilt the compact refrigerator at an angle of more than 45 degrees while moving it.
NOTE: Allow the compact refrigerator to stand upright for approximately 24 hours before connecting the power source. This will let the compressor settle from being handled during transportation.
Starting the compact refrigerator too soon and not allowing the compressor to settle can result in a lack of cooling.
Also before operating, clean the refrigerator thoroughly. Wipe the outside with a soft dry cloth and wipe the interior with a clean moist cloth.
If discarding an old refrigerator, please see “Disposal Instructions” on page 3.
LOCATION OF THE COMPACT REFRIGERATOR
Find a suitable area for your compact refrigerator. Do not place the refrigerator outside, or any other place where the refrigerator will be exposed to water, sunlight, or other harsh weather conditions. The refrigerator must not be placed in environments where the ambient temperature drops below 10°C (50°F) degrees because it will not run often enough to maintain the desired temperatures.
PLACEMENT INSTRUCTIONS
The compact refrigerator is a free standing appliance and can be installed next to counters and walls. It can not be placed under a counter.
For the compact refrigerator to function properly, it is important to have a clearance of at least 15 cm (6” inches) from the back of the compact refrigerator to the surface next to it. A clearance of at least 10 cm (4” inches) is required from each side of the compact refrigerator to the surface next to it.
| 15 cm / 6” inches |
| |
| wall |
| |
10 cm / |
| 10 cm / | |
4” inches | back | ||
4” inches | |||
|
| ||
| Top of |
| |
| Refrigerator |
| |
| front |
|
NOTE: THE SPACING IS NECESSARY FOR AIR CIRCULATION
ADJUSTABLE LEG
ADJUSTING THE LEGS OF THE REFRIGERATOR
The compact refrigerator has adjustable legs on the front of the unit. These legs can be used to adjust the height and stabilize the unit. To lengthen the leg, turn the leg counter- clockwise and to shorten the leg, turn clockwise.
6
