SETTING UP THE WINE CHILLER
UNPACKING
Remove all packing materials and accessories. Examine the chiller for any damage such as dents or broken door. Do not install if chiller is damaged.
Allow the chiller to stand upright for approximately 2 hours before connecting the power source.
If discarding an old chiller, please see “Important Safety Instructions” on page 3.
ASSEMBLING THE DOOR
To save shipping space and avoid damage of the wine chiller during transportation, the door handle of this unit is shipped unassembled. Before setting up the chiller, please assemble the door handle as follows:
1) | Screw | 3) | Rubber Seal |
2) | Door handle | 4) | Door Panel |
Locate the door handle and 2 screws attached inside the cabinet.
With the 2 screws attached, fasten the door handle onto the frame of the door panel as illustrated.
You may be required to pull away a section of the rubber seal to find the screw holes. Simply pull off the seal and place back into the grooves.
1.
2.
3.
4.
WOOD RACKS IN THE CHILLER
The wine chiller comes with wood racks. They are already in place in the chiller upon delivery. For your convenience, they easily slide in and out. If you remove the racks for any reason, make sure the wood attached edge always faces out when placing them back in the chiller.
LOCATION OF THE CHILLER
Find a suitable area for your wine chiller. Do not place the chiller outside, or any other place where the chiller will be exposed to water or other harsh weather conditions. The chiller must not be placed in environments where the ambient temperature drops below 18°C (65°F ) degrees or goes above 29°C (85°F) degrees. The ideal ambient temperature is 22.2°C (72°F).
CAUTION: DO NOT PLACE THE WINE CHILLER IN A COLD LOCATION. IT WILL INCREASE THE RISK OF FREEZING.
6
