Honeywell AP-010-BT, AP-100-BT manual 10

INSTALLATION

USB Host Connections

1.Turn off power to the host system.

2.Plug the USB connector into the to a dedicated USB serial port.

3. Turn on power to the host system. Figure 7. USB Host Connections

Keyboard Wedge Host Connections

1.Turn off power to the host system.

2.Disconnect the keyboard from the host system.

3.Connect the “Y” ends of the communication cable to the keyboard and the keyboard port on the host system. If necessary, use the male/female adapter cable supplied with the device for proper connections.

4.Turn on power to the host system.

RS485S Host Connections

1.Turn off power to the host system.

2.Connect the SDL connector into a dedicated Port 9 on the host system.

3.Plug the external power supply into the power jack on the PowerLink cable

Figure 8. KBW Host Connections

Figure 9. RS485 Host Connections

Check the AC input requirements of the power supply verify the voltage matches the AC outlet. The outlet must be located near the equipment.

See caution information on page 4.

4.Connect AC power to the transformer.

5.Turn on power to the host system.

SApplicable for IBM® Host applications.

6 www.metrologic.com