INSTALLATION

Cable to Access Point Connection

1.Align the tab on the modular connector with the pinhole on the access point device (see figure below).

2.Insert the modular connector into the device’s socket.

3.Test the cable’s connection to ensure the connector lock has engaged. Important: If the cable is not fully latched, the unit can power intermittently.

4.Refer to pages 5 – 6 for the appropriate host connections applicable to the interface type.

Figure 5. Cable Installation

RS232 Host Connections

1.Turn off power to the host system.

2.Connect the female, 9-Pin D-type connector to a dedicated RS232 communication port on the host system.

3.Plug the external power supply into

the power jack on the PowerLink

Figure 6. RS232 Host Connections

cable.

 

Check the AC input requirements of the power supply verify the voltage matches the AC outlet. The outlet must be located near the equipment.

See caution information on page 4.

4.Connect AC power to the transformer.

5.Turn on power to the host system.

5