CONFIGURATION PROCEDURES

CodeXML Protocol Compatibility

The CodeXML protocol does not support page/disconnect button functions, or scanner firmware upgrades through the access point device and Metroset2.

When a scanner is using the CodeXML protocol, configuration data is stored in the scanner. The stored data is not transmitted to the access point device. Special configuration steps are required for the customization of system formats and protocols. Instructions on how to configure a scanner in the CodeXML protocol mode via the access point device are outlined on page 11.

CodeXML Firmware Requirements

Scanner Model

Firmware Version

Focus BT

15701 or higher

To configure a scanner to use the CodeXML protocol:

1.Scan the Disable Metrologic Protocol bar code.

Disable Metro Protocol

³ 1 2 5 6 0 4

2.Scan the Recall Defaults bar code.

Recall Defaults

³ 9 9 9 9 9 8

3.Scan the Enable CodeXML Protocol bar code.

Enable CodeXML Protocol

³ 1 2 5 6 1 7

4.Scan the address bar code located on the top of the access point device (see Figure 11, on page 8) to establish a communication link between the scanner and access point.

5.The scanner will beep to indicate a connection has been established.

10 www.metrologic.com