Honeywell CM721 manual Programming the CM727, Monday to Friday Period

‘Efficient Daily Use’ PROGRAMMING THE CM727

The Built-in Heating Program

The built-in heating program has 4 temperature level changes per day that can be set between 3.00am and 2.50am the following day - allowing you to maintain the evening temperature after midnight. Each temperature level can be set between 5°C and 35°C, and adjusted in 0.5°C increments. The factory default program for heating is as follows.

Monday to Friday	Period	1	2	3	4
(Day 1 to 5)	Time	6:30	8:00	18:00	22:30
	Temperature	21°C	18°C	21°C	16°C
Saturday & Sunday	Period	1	2	3	4
(Day 6 & 7)	Time	8:00	10:00	18:00	23:00
	Temperature	21°C	21°C	21°C	16°C

Reviewing the Heating Program

To review or edit the heating program use the PROGRAM or buttons to navigate between the 4 individual programming periods for that day. Use the DATE/DAY button to step through each day of the week, so the complete 7 day heating program can be reviewed or edited.

Modifying the Heating Program

To change the heating program:

a. Press either of the PROGRAM or buttons to enter the programming mode. The time / temperature settings for period 1 on Monday (Day 1) will be flashing as shown. The active period is highlighted by a flashing square around the numbers at the bottom of the screen and the selected day is shown with the day indicator.

1 2 3 4 5 6 7

1 2 3 4

b.To adjust the period start time use the or buttons, the ‘OK?’ indicator will be displayed to confirm the change. Holding the button down will change the time quickly.

Note: If you are pressing the or buttons and the display flashes the next period, it means the next period will be pushed forward.

c.Once the required time is reached press the green button to confirm.

Note: If the original time setting did not require adjustment press the green button to move to step ‘d’.

d.The temperature setting for period 1 on Monday (Day 1) will now be flashing. To adjust this

press the or buttons and confirm the setting again by pressing the green button.

e.The next time and temperature period will now be active. Adjust this by repeating steps b - d above until all 4 periods are set for Monday or press the AUTO button to run the program as set, at any time.

You now have a choice of how to set the program for the next day:

10