| ‘Getting Started’ |
This section shows you how to setup and run the thermostat in 3 simple steps:
STEP 1: Installing the Batteries
Note: Please follow the instructions in this section only if the thermostat screen is blank (no symbols or digits are displayed). If the room temperature is already displayed move on to Step 2: Setting the Date and Time.
To install the Batteries:
a.Lift up the front cover of the thermostat to reveal the battery cover and product controls.
b.Remove the battery cover by pressing down and sliding out.
c.Insert the 2 x AA LR6 Alkaline Batteries supplied with the thermostat, ensuring the correct orientation (see ‘Controls Layout’ on page 2).
d.After a short pause the thermostat will display information on the screen and is now ready for use.
e.Replace the battery cover by sliding it firmly back into the front of the thermostat.
STEP 2: Setting the Date and Time
To set the Date and Time:
a.Press the DATE button to begin setting the date. When you set the date for the first time after the batteries are inserted, the
display will show:
Press the 
or 
buttons to set the current day of the month (e.g. d 01 = 1st day of the month) then press the green 
button to confirm.
b. Press the 
or 
buttons to set the current month of the
year (e.g. m 01 = January) then press the green 
button to confirm.
c.Press the 
or 
buttons to set the current year (e.g. yr 06
= 2006) then press the green 
button to confirm.
The date is now stored.
d.Use the 
or 
buttons to set the correct time then press
the green 
button to confirm. Each press of the buttons will change the time by one minute and holding them down will change the time slowly at first and get progressively quicker.
Note: If this mode is entered accidentally then press the AUTO, MAN or OFF buttons to exit.
STEP 3: Running the Built-in Heating Program
AM
The thermostat is now ready for operation. Press the AUTO button and the
3
