Installation Guide 5
2.2.3 Locating the Room Thermostat
While still in the Test Mode, as described in section 2.2.2, the room thermostat should be located taking
the following into consideration and reviewing the illustrations below:
1.
Find a suitable location where the signal transmission is reliable. Reliable transmission is indicated when
the Relay Box is flashing the green LED every 6 seconds. NOTE: The Relay Box relay will be off.
2. Install the room thermostat EITHER on the wall using the wall bracket OR attach the optional table stand
as shown in below.
3. Exit the Test Mode by moving the setting slider to the required operating mode (AUTO or OFF).
2.3 System CheckNow a simple test can be completed to check the full system has been installed correctly:
1. Set the slider switch to the OFF mode.
2. Check the boiler supply is on and check that the green LED on the Relay Box is off.
3. Set the slider switch to the MAN mode.
4. Adjust the setpoint up to the maximum (35°C) by pressing the button. The boiler should come on
(green LED ON on Relay Box) after a few seconds and the symbol appears on the room thermostat
LCD display.
5. Set the slider switch to the OFF mode. The boiler will go off (green LED OFF on Relay Box) after a few
seconds and the symbol disappears.
6. Check the system operation by moving the slider between MAN and OFF modes several times, bearing
in mind the switching delay referred to above.
Now, you should have completed the installation successfully - to begin operating at the default factory
settings move the slider to the AUTO mode or select PROG to modify the built-in heating program
accordingly.
Wall bracket Table stand
•Theroomthermostatshouldbeinstalledinanopenspaceforbestperformanceasitisaradiofrequencydevice.
•
Leave at least 30cm distance from any metal objects including wall boxes and at least 1 metre from any other
electrical equipment eg. radio, TV, PC etc.
•Donotmountontometalwallboxes.•ItisrecommendedthattheRelayBoxisfullyinstalled.
✓
✗✗
1.2m