HD3MDIP/X Network Camera Reference Guide

Flush Mount (with or

4S box (not supplied and optional)

 

without 4S box)

 

1.

Use the screws (supplied) to

Adapter plate

 

connect the adapter plate directly

 

Screws

 

to the ceiling or wall.

 

Or

(supplied)

 

Use your own screws to connect

Screw caps

 

the adapter plate to the 4S box (not

Camera

 

supplied) which is attached to the

 

assembly

 

ceiling or wall.

 

 

2.

Connect the wires (see Connecting

Turret

 

the Wires on page 19).

3.

Secure the camera assembly to the

 

 

adapter plate by twisting clockwise

 

 

until it clicks securely in place.

Bubble

4.

Adjust the camera’s field of view

 

 

(see Adjusting the Camera FOV

 

 

(Field of View) on page 25).

 

5.

Install the turret by clicking it into

 

 

place.

Note Installation with 4S box shown

6.

Install the bubble by placing it on

 

the camera with the tabs to the left

of the slots, then turning it clockwise until the tabs click securely into place.

Restore Factory Defaults

Your network camera has a Factory Reset switch located inside the camera (see Figure 2-6on page 22). This switch restores your camera settings and passwords to their default settings. Press and hold the Reset switch for three seconds. This will reset the factory-configured parameters such as the compression settings, the camera tamper detection settings, and the Video Motion Detection settings. It will not impact network IP address configurations.

Adjusting the Camera FOV (Field of View)

To adjust the HD3MDIP/X camera:

1.Apply power to the camera and watch the video on a connected local video monitor (see Figure 2-7on page 22 to connect a local video monitor).

2.Loosen the setscrew that locks the gimbal assembly in place (see Figure 2-8) to adjust the horizontal rotation.

Document 800-04132V1 Rev A

25

01/10