Installation and Setup

3.Adjust the gimbal assembly to the desired view.

4.Re-tighten the locking screw to lock the gimbal assembly in place.

Setscrew (loosen to adjust horizontal rotation)

Note Orient the camera as shown in Figure 2-8to maintain the correct picture orientation.

Figure 2-8 Gimbal Adjustment

Top view

Angle view

Legend

A = Tilt rotation

B = Horizontal rotation

C = Pan rotation

Set focal length

Loosen set screw to adjust

(bottom)

Tilt Rotation (A)

Adjusting the Lens Focus

Lenses are pre-focused at the factory. They might require a final adjustment after installation because the optical effect of the bubble might cause a slight defocusing of the lens.

TECH TIP! To check the focus, hold the bubble over the lens while making any adjustments.

To adjust the camera direction, view angle, and focus, connect the local video out to the video monitor using the supplied BNC video cable.

26