Assembly

Step 1: Install Support Legs

To install support legs, you will need:

‰25 mm full-thread hex bolts (2)

‰5/16" washers (2)

‰13 mm flange serrated nuts (6)

‰16 mm full-thread hex bolts (4)

‰Socket Wrench with 10 mm Socket*

*Not included

Generator must be empty of engine oil and fuel.

Drain engine oil and fuel, if necessary.

Generator is heavy! Lifting generator can cause back or other bodily injury. NEVER lift generator without assistance.

1.Be sure generator is set on flat, level surface.

2.Stand at side of generator opposite recoil starter handle. Grip frame; carefully pull up and push to tilt generator backward.

5.Attach a rubber stopper to bottom of each support leg using a 25 mm full-thread hex bolt and 13 mm flange serrated nut; tighten until securely seated.

FIGURE 4: Rubber Stopper Attachment to Support Leg

6.Attach each support leg to pre-drilled holes on bottom of generator frame, using 16 mm full-thread hex bolts and 13 mm flange serrated nuts; tighten until securely seated.

FIGURE 5: Support Leg Attachment to Generator

FIGURE 3: Tip onto Generator Recoil Side

3.Gently set generator onto recoil side.

4.Place 5/16" washer in center of each rubber stopper.

8

www.honeywellgenerators.com

HW5500/5500E Portable Generator Owner’s Manual