Honeywell HZ-519 Fig Basic Control Panel Operation Power, Mode Set Temperature, Mode Set Timer

IMPORTANT SAFETY INSTRUCTIONS REGARDING THE PLUG ON YOUR PRODUCT

•

•FIG 1

BASIC CONTROL PANEL OPERATION:

POWER

Continuous Run

Power

Mode	70	o
		F
Back-Lit		F/C

•Press Power once to turn the heater on.

•Press Power again to turn the heater off.

MODE: SET TEMPERATURE

Set Temperature

Power
Mode
Back-Lit	F/C

•Press Mode until the Temperature icon blinks. The current room temperature will appear.

•Use the Up or Down arrows to set the desired tem- perature.

•The Temperature icon will stop blinking and the cur- rent room temperature will reappear after the desired temperature is set.

•The heater will turn-off shortly after the desired tem- perature is reached and the Power light above the display will blink.

•The heater will turn back on when the room tempera- ture drops approximately 2 degrees below the desired temperature. The Power light will stop blink- ing and will remain lit.

MODE: SET TIMER

Timer

Power
Mode
Back-Lit	F/C

•Press Mode until the Timer icon blinks. The Hour display will appear.

•Use the Up or Down arrows to set an operation time between 1 and 10 hours.

•The heater will turn-off when time runs out.

2

www.sylvane.com 1-800-934-9194