4
Figure 3. StratosS Calibration Seal and Switch Location
5. Disconnect the scale-to-host RS232 cable from the unit (dual cable
interface only.)
Figure 4. Disconnect scale-to-host RS232 Cable
6. Reinstall the platter and connect AC power to the scanner.
Note: Check the AC input requirements of the power supply to make sure
the voltage matches the AC outlet. The outlet should be located
near the equipment and be easily accessible.
Honeywell recommends using a switched AC outlet. The switch
should be located on the operator’s side of the checkout counter in
close proximity to the scanner/scale to facilitate calibration and
service of the unit.
Caution: To maintain compliance with applicable standards, all circuits connected to
the imager must meet the requirements for SELV (Safety Extra Low Voltage)
according to EN/IEC 60950-1.
To maintain compliance with standard CSA C22.2 No. 60950-1/UL 60950-1
and norm EN/IEC 60950-1, the power source should meet applicable
performance requirements for a limited power source.