5
7. If the system is equipped with a remote scale display, it will read H - - -.
8. Use the vertical window to scan the desired scale configuration bar
codes, located on pages 7 - 21.
Figure 5.
9. Reconnect the scale-to-host RS232 cable to the scanner (dual cable
interface only.)
Figure 6.
10. The scale must now be calibrated, tested and certified by local Weights
and Measures authorities before it can be placed in service.
For further details on calibration procedures for Weights and Measures
certification, refer to the Scale Operation: Calibration section of the Stratos
Installation and User’s Guide.
Important Notes The certification of the weighing mechanism of the scale version of this
scanner is subject to federal, state and local Weights and Measures
statutes and regulations and can only be performed by authorized
government agencies and/or their duly registered agents. Each time the
scale or weighing mechanism is calibrated, it should be properly sealed
with a paper seal or a wire seal prior to being placed into service in
commerce.
It is the responsibility of the owner of the scale to confirm compliance
with the relevant Weights and Measures statutes and regulations
applicable in your area by checking with the appropriate government
agency before placing a newly calibrated unit into service or removing
any official seals.
Type of seal to be used will depend on the guidelines specified by the
local Weights and Measures authorities.