3.Position the remote sensor so that is faces the main unit (receiver), minimizing obstructions such as doors, walls, and furniture.
4.Though the remote sensors are
BATTERY INSTALLATION
REMOTE SENSOR
NOTE: Install the batteries; select the channel and type of temperature (ºC/ºF) before you mount the sensor.
1.Remove the screws from the battery compartment with a small Phillips screwdriver.
2.Set the channel. The switch is located in the battery compartment. Channel 1 is typically selected if only 1 remote sensor is being used.
3.If you are using more than one sensor, select a different channel for each sensor.
4.Install two “AA” size alkaline batteries (not included) matching to the polarities shown in the battery compartment.
5.Replace the battery compartment door and secure the screws.
6.Secure the remote sensor in the desired location.
BATTERY INSTALLATION
MAIN UNIT
1.Open the battery compartment door.
2.Install two AA batteries (not included) matching to the polarities shown.
3.Replace the battery compartment door.
LOW BATTERY WARNING
A
GETTING STARTED
After batteries are installed, remote sensors will transmit a temperature readings at 45 second intervals. The main unit may take up to 2 minutes to receive the initial readings.
Upon successful reception, remote temperature will be displayed. The main unit will automatically update readings at
7
If no signals are received from the remote sensor(s) within 2 minutes, dashes “
” will be displayed.
Press and hold DOWN button [ – ] for 2 seconds to activate another signal search.
CHECKING REMOTE AND INDOOR TEMPERATURES The indoor temperature is shown on the middle line of the main unit display. The remote temperature is shown on the top line of the display. The wave icon near the remote sensor reading indicates that there is a good signal reception from the remote unit. If there is no signal received from the remote unit for more
than 2 minutes, a dashes “ 
” will be displayed. Hold [ – ] button for 2 seconds to enforce an immediate search.
CONTINUOUS PROJECTION
DC 5V
Insert 2 AA batteries and connect the included AC adapter (AC120V,
8
