If everything listed above in order and there is no reception anyway, please perform the following steps:
1.Bring main unit and remote sensor close together.
2.Remove 4 small screws from the back of the remote sensor and open the battery compartment.
3.Remove the batteries from the battery compartment and reinstall them in the same manner. Remote sensor
LED indicator will flash showing transmission of the signal.
4.Remove the batteries from the main unit and reinstall them in the same manner.
5.On the main unit select the same channel number as
set on the remote sensor. Remote temperature appeared on the main unit’s display will show that transmission is being received successfully.
TRANSMISSION COLLISION
Signals from other household devices, such as doorbells, home security systems, and entry controls, may interfere with this product and may cause temporary reception failure. This is normal and will not affect the general performance of the product. The transmission and reception of temperature readings will resume once the interference subsides.
HOW TO SET THE RADIO CONTROLLED CLOCK
1.After the main unit receives temperature readings from the remote sensor, the WWVB time signal receiver will automatically search for the time signal. It takes about
2.If the radio signal is received, the date and time will be set automatically, and the [ 
] icon will appear.
3.If after 8 minutes the time signal has not been received, press the “MODE” button to set the time manually. The clock will continue to search for the WWVB time signal daily from 1:00 am to 4:30 am.
When the signal has been successfully received, the time and date will be updated automatically.
13
CALENDAR AND CLOCK DISPLAY MODES
The date is displayed in
MANUAL SETTINGS
TIME ZONE
1. Press MODE to select the time with the day of week display mode.
2. Select the time zone by pressing and holding the “ + ” button for 3 seconds.
3. Keep holding until the desired time zone (Pacific, Mountain, Central or Eastern) is selected on the display map.
YEAR, DATE, TIME, TEMPERATURE UNIT Press and hold MODE for 3 seconds: the year will flash. Press “ + ” or “ - ” to change the flashing digits.
After the first value is set, press MODE again. Continue setting month, day, hour, minute, display language, Fahrenheit or Celsius display. When you’ve set the last value, press MODE for the last time to return to regular mode.
ALARMS
* Weekday Alarm
The alarm will sound and the alarm icon will flash at the set time Mondays through Fridays.
* Single Day Alarm
The alarm will sound and the alarm icon will flash at the set time, but will not activate on subsequent days.
*
If the remote temperature is 32º F/0º C or below, the
to set the
14
