REMOTE TEMPERATURE SENSOR
NOTE: Install the batteries; select the channel and temperature in C° or F° before mounting the remote temperature sensor.
•Remove the screws from the battery compartment with a small Phillips screwdriver.
•Set the channel. The switch is located in the battery compartment. Channel 1 is typically selected if only one remote sensor is being used.
•Install 2 “AA” size alkaline batteries (not included) matching the polarities shown in the battery compartment.
•Replace the battery compartment door and secure the screws.
•Secure remote temperature sensor in the desired location.
MAIN UNIT
•Open the battery compartment door.
•Install 2 batteries
•Replace the battery compartment door.
LOW BATTERY WARNING
A ] will appear on the remote rainfall reading line and the indoor or remote temperature reading line of the main unit, warning that the corresponding batteries need replacement.
HOW TO USE THE TABLE STAND
The main unit has a removable table stand that supports it on the flat surface.
Attach table stand to the bottom of the main unit in the slots provided. The main unit can also be mounted on the wall using the recessed screw hole. The table stand must be removed prior to mounting. The remote temperature sensor can be similarly mounted or placed on a flat surface.
GETTING STARTED
After batteries are installed; remote temperature sensor will transmit temperature readings at about 45 second intervals. The remote rain gauge will transmit rainfall data at about 183 second intervals. The main unit may take up to two minutes to receive the initial readings. Upon successful reception, the rainfall reading (0.00) will appear on the top line of the main unit’s display and the remote temperature will appear on the line below. The main unit will automatically update readings at
If no signals received from the remote temperature sensor within two minutes, dashes [- -
Press and hold the front panel DOWN (▼) button on the main unit for two seconds or until Rain symbol will start flashing, to initiate a signal search for the remote rainfall.
Press and hold the back panel DOWN (▼) button on the main unit for two seconds to initiate a signal search for the remote temperature.
15 | 15 | 16 |