MAXIMUM AND MINIMUM TEMPERATURE
The maximum and minimum record of the indoor and remote temperature will be automatically stored in the memory of the main unit (receiver). Main unit will display the minimum, maximum and the current reading upon each press of MEMORY button. The unit will return to the current temperature display in 15 seconds. To clear the memory, press and hold "MEM" for 3 seconds and all stored readings will be erased.
TEMPERATURE TRENDS
The remote temperature trend indicator shows the trend of temperatures collected at particular remote sight. There are three trends will be shown: rising, steady, and falling.
Arrow | TREND | TREND | TREND | |
|
|
| ||
indicator |
|
|
| |
Temperature | Rising | Steady | Falling | |
Trend | ||||
|
|
|
LOST COMMUNICATIONS
If the main unit display for the remote sensor goes blank, press and hold [ ] button for 2 seconds to begin a new signal search. If the signal still isn’t received, please make sure that:
1.The remote sensor is in its proper location.
2.The distance between main and remote units is not over 100 feet.
3.The path between the units is clear of obstacles. Shorten the distance between units if necessary.
4.Fresh batteries are installed correctly in both remote and main units.
Note: When the temperature falls below freezing, the batteries in outdoor remote sensors may have reduced voltage supply and a shorter effective range. We recommend to
Use lithium-ion batteries at the temperatures below 32°F
9
If everything listed above is in order and there is no reception anyway, please perform the following steps:
1.Bring main unit and remote sensor close together.
2.Remove 4 small screws from the back of the remote sensor and open the battery compartment.
3.Remove the batteries from the battery compartment and reinstall them in the same manner. Remote sensor
LED indicator will flash showing transmission of the signal.
4.Remove the batteries from the main unit and reinstall them in the same manner.
5.On the main unit select the same channel number as set on the remote sensor. Outdoor temperature
on the display will show that transmission is being received successfully .
TRANSMISSION COLLISION
Signals from other household devices, such as doorbells, home security systems, and entry controls, may interfere with this product and may cause temporary reception failure. This is normal and will not affect the general performance of the product. The transmission and reception of temperature readings will resume once the interference subsides.
ATOMIC CLOCK
1.After the main unit receives temperature readings from the remote sensor(s), the WWVB time signal receiver will automatically search for the time signal. This takes about
2.If the radio signal is received, the date and time will be set automatically, and the [ 
] icon will appear.
3.If in 8 minutes the time signal has not been received, press “MODE” button to set the time manually. Always place the main unit by the window for better reception.
4.The clock will continue to search for the WWVB time signal daily for every hour between 1:00 am and 4:30 am. After the signal has been successfully received, the time and date will be updated automatically.
CALENDAR AND CLOCK DISPLAY MODES
Date is displayed in
10
