Honeywell TE211W user manual FCC Statement, This device may not cause harmful interference

SPECIFICATIONS
Temperature Measurement
Main unit
Indoor Temperature	: -5.0°C to +50.0°C /
Proposed operating range
Temperature resolution	23.0°F to 158.0°F
	: 0.1°C/ 0.2°F
Remote Sensor
Proposed operating range	: -20°C to + 70°C /
with alkaline batteries
Proposed operating range	-4°F to 158°F
	: - 38°F to 158°F
with lithium batteries
Temperature resolution	( -38.8 C° to 70°C)
	: 0.1°C/ 0.2°F
RF Transmission Frequency	: 433 MHz
Maximum number of Remote sensors	: 3
RF Transmission Range	: Maximum 100 feet
Temperature sampling cycle	: approximately
	45 seconds

Calendar and Clock

12/24 hour display in hh : mm format

Date Format: Month – Day format

Day of week: User- selectable in 5 languages (English, Spanish, French, German, Italian)

Dual 4-minute crescendo alarm with snooze Pre-alarm for ice alert with programmable intervals of 15, 30, 45, 60 and 90 minutes

Blue Backlight

Power

Main unit: 2 AA batteries (not included)

Remote Sensor: 2 AA batteries (not included)

Dimensions

Main unit: 3.54(L) x 4.92(H) x 1.89(D) inches

Remote sensor: 2.38(L) x 4(H) x 1 (D) inch

13

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2)This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modification to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment had been tested and found to comply with the limits for a Class B Digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1.Reorient or relocate the receiving antenna.

2.Increase the separation between the equipment and receiver.

3.Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

4.Consult the dealer or an experienced radio / TV technician for help.

14