BATTERY INSTALLATION
MAIN UNIT
The Wireless Indoor/Outdoor Thermometer main unit uses 2 “AA” batteries (not included). When the LCD becomes dim or the respective low battery indicator shows up on the indoor or remote temperature display, the battery replacement is required. To install or replace the batteries, please follow these steps:
1.Remove the battery compartment door on the back of the main unit.
2.Insert 2 “AA” size batteries (not included) matching the polarities shown.
3.Replace the battery compartment door.
HOW TO USE THE TABLE STAND OR WALL MOUNTING
The main unit has a removable table stand, that supports it on a flat surface. The unit can also be mounted on
the wall using the recessed screw hole. The stand must be removed prior to mounting. The remote sensor can be similarly mounted or placed on a flat surface.
GETTING STARTED
1.After the batteries are installed, remote sensor will transmit the temperature readings at adout 45 second intervals.
2.The main unit may take up 2 minutes to receive the initial readings.
3.Upon successful reception, the remote temperature will be displayed under the top line of the main unit LCD display, and the indoor temperature will be displayed below the remote one.
4.The main unit will automatically update readings at
5.After the main unit finishes searching for the temperature signal from the remote unit(s), the WWVB time signal receiver will start searching for the atomic time signal. It takes about
6
Always place main unit by the window for better reception. If in 8 minutes the WWVB time signal has not been received, use the MODE button to set the time manually (see "setting the time and date manually" section.)
The clock will continue to search for the WWVB time signal daily from 1:00am to 4:30am. If reception is successful, the time and date will be updated automatically.
6.You may activate the WWVB receiver at any time by pressing and holding the 
button for 3 seconds in the Hour/Minute/Second display.
FUNCTION KEYS
Your Wireless Forecaster has 6 easy - to - use function keys that control its operation:
Use the MODE button:
*To set the time manually
*To view the calendar
Use the 
button:
*To increase the hour, minute, year, month and date
*To select 12/24 hour format
*To select temperature display unit (ºC or ºF )
*To select the weekday language
*To select the time zone
*To activate reception of the WWVB signal
Use the button:
*To decrease the hour, minute, year, month and date
*To select 12/24 hour format
*To select temperature display unit (ºC or ºF )
*To select the weekday language
*To search for the remote sensor signal
Use the CHANNEL button:
* To view the reading of different remote sensor(s)
Use the MEM button:
*To view the maximum or the minimum indoor or remote temperature
*To clear the previous temperature records
7
