Honeywell Th4210D Installer setup, Installer system test

PRO TH4210D Programmable Thermostat

To begin, press and holdthe and

buttons until the display changes

Function

number

Press to change settings

Press to advance to next function

Press and hold to exit and save settings

Setting

Installer setup

Follow the procedure below to configure the thermostat to match the installed

heating/cooling system,and customize feature operation as desired.

Setup

Installer system test

After completing the installer setup above,press the button again to begin a

system test (see next page).

Press and hold both buttons

Setup Function Settings & Options

5 For gas or oil furnaces of less than 90% efficiency

1 For steam or gravity systems

3 For hot water systems & furnaces of over 90% efficiency

9 For electric furnaces

[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH]

9 For electric emergency heat

1 For steam or gravity systems

3 For hot water systems & furnaces of over 90% efficiency

5 For gas or oil furnaces of less than 90% efficiency

[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH]

3 Recommended for most compressors

[Other cycle rate options: 1, 2, 4, 5 or 6 CPH]

1 On **See page 9

0Off

0 Fahrenheit

1 Celsius

5 Five-minute compressor off time **See page 9

[Other options: 0, 1, 2, 3 or 4-minute off time]

Auxiliary heat

cycle rate

(CPH: cycles/hour)

Emergency heat

cycle rate (CPH)

Compressor

cycle rate (CPH)

Adaptive Intelligent

Recovery

Temperature

display

Compressor

protection